A pad for the backup power unit you bought after the last long outage, the storage building the HOA approved, or the hot tub that needs dead-level support. Sized to what sits on it and raised a little above flat, wet ground.
Credibility comes from how it's built, not from promises. Here's the order of operations on every concrete pads & slabs job.
A backup power unit, a hot tub and a shop floor put very different loads on concrete. We size the thickness and steel to the equipment, using the manufacturer's pad requirements where they exist.
On level lots we usually finish a pad slightly above the surrounding ground and slope the area around it, so rain does not pond against equipment or soak the base.
We compact the base for the soil on your lot and set rebar or mesh to match the load, with steel held up inside the slab rather than lying in the dirt.
Under an enclosed building or a shop floor we lay a vapor barrier so ground moisture does not wick up into the slab and everything stored on it.
Control joints go where the slab needs them, the pour is cured with the heat in mind, and you get a date for when it can carry the load.
Most contractors vanish after the deposit. We pick up the phone, show up when we say, and stand behind the work after the truck leaves. The follow-through is the difference.
A foreman we know runs your job and a vetted crew does the work, managed by Lucky's, one company accountable from the first call to the final walkthrough.
COI and lien waivers on file before we break ground. The documentation that lets commercial clients pay and gives homeowners peace of mind.
Prepped subgrade, reinforced and mixed to spec for the job, and proper curing. We build credibility through the process, not promises. On concrete pads & slabs, that starts with start with what will sit on it.
Size, thickness, reinforcement, any vapor barrier, site access for the truck, and how much the ground needs to be built up or graded. A small AC pad and a shop floor are very different jobs, so we quote each one after seeing the spot.
Yes. Pads for whole-home backup power have become a common request around the Houston area. We size the pad to the unit's requirements, keep it level and slightly raised, and coordinate placement with whoever is doing the electrical and gas work.
It follows the load. A pad for a small storage building is much lighter than a garage or shop floor carrying vehicles, and a hot tub puts a heavy weight on a small area. We match thickness and steel to the real use.
It can. Harris County has rules about placing fill in mapped floodplains, which can matter if a pad needs to be raised. We check your lot's status and talk through what that means before planning the work.
For enclosed or conditioned spaces, usually yes, because ground moisture moves up through concrete and into whatever sits on it. For an open equipment pad it is often unnecessary. We make the call based on the use.
In most deed-restricted neighborhoods the building itself needs approval, and the slab goes with it. We provide the slab dimensions and location for the request so it can be reviewed together.
You'll hear back from a real person, usually the same day. No call center, no runaround, no chasing us down.
Booking up fast this season. Or call (346) 480-5442